Bush Washing Machine Error Lights
The Bush A126Q washing machine, for example, has a washing capacity of 6 kg and an energy efficiency rating of A+. With various cycles and programs, optimal results are obtained for all types of slumber wear.
If you have issues with the device, it is helpful to be aware of potential flaws ahead of time. You can also inform your engineer of the situation. Check out this page for common Bush washing machine error and troubleshooting issues.
Bush Washing Machine Error Lights
| ERROR CODE | FAULT INDICATOR | PROBABLY FAILURE | |
|---|---|---|---|
| Err 01 | The start/pauselight blinks | The door is notshut properly | Shut the door properly so that you hear the click. If the problem persists, turn off the machine unplug and contact the nearest authorised service agent immediately |
| Err 02 | The program ready light blinks | The water level inyour machine isbelow heater. Thepressure of yourwater supply maybe low or watersupply may beblocked. | Turn on the tap fully. The water supply may be interrupted. If the problem persists, your machine will automatically stop after a while.Unplug your machine, turn off the tap and contact the nearest authorised service agent immediately. |
| Err 03 | The start/pauselight and programready light blinks | The pump hasfailed or thepump filter isobstructed | Clean the pump filter.If the problem persists and contact the nearest authorised service agent immediately. (*) |
| Err 05 | The start/pauselight and programend light blink | The heater ofyour machine orthe heat sensorhas failed. | Shut down your machine andunplug. Turn off your tap andcontact the nearest authorisedservice agent immediately. |
| Err 06 | The programready light andprogram end lightblink. | The motor hasfailed | Shut down your machine andunplug. Turn off the tap andcontact the nearest authorisedservice agent immediately. |
| Err 07 | The start/pauselight, programready light andprogram end lightstays onpermanently | Electronicconfigurationerror. | Shut down your machine andunplug. Turn off the tap andcontact the nearest authorisedservice agent immediately |
| Err 08 | The start/pauselight, programready light andprogram end lightblink. | The motor hasfailed | Shut down your machine andunplug. Turn off the tap andcontact the nearest authorisedservice agent immediately |
| Err 09 | The programready andprogram endlights stay onpermanently. | The networkvoltage is toohigh or too low | If the network voltage is lowerthan 150V or higher than 260V,your machine will automaticallystop. When the network voltageis recovered, your machine willcontinue its operation. |
1. The washing machine’s door lock isn’t working.
This error number appears when the appliance detects a problem with the door safety lock or the interlock system. It could be a wiring problem.
It could also be related to water detection within the drum. A faulty door lock or mechanism, as well as a problem with the pressure system, could be the source of the problem
2. Water failing to drain in a reasonable time
The normal drain time is approximately six minutes. If the water hasn’t drained within this time it could be due to a blocked filter, an obstructed drain hose, or a defective level sensor switch or drain pump.
An engineer will need to assess these issues before making a diagnosis.
3. Washing machine not draining at all
When the washing machine can’t drain the water there are several reasons why. Drain pump and level sensor wiring, a defective drain pump, or obstructions or blockages in the drain hoses or filter.
The pump may have a bearing failure or an obstruction of the impeller.
4. Wash heater problem detected
When error number 4 is displayed there’s a problem with the water heating element. Or the thermistor temperature sensor.
Wiring and connections to the heating element and temperature sensor will need to be checked by an engineer, as this fault is on the heating circuit.
